Brake bleeding with a Motive power bleeder pump step by step

“Brake bleeding with a Motive power bleeder pump step by step” with video from Youtube

Video “Brake bleeding with a Motive power bleeder pump step by step”

Other method with a Mityvac vacuum pump here :
How to use Motive power bleeder pump to bleed brake of a Renault Megane / Scenic. Step by step procedure.

Bleed/change/replace hydraulic fluid brake by yourself auto car vehicle maintenance tools parts accessories engine mechanics do-it-yourself diy tutorial tuto.

The introduction of air in the circuit can be fatal, test brake before hitting the road! Follow manufacturer’s recommended bleeding sequence.

This video does not constitute or replace a real specialized technical manual, and was only made ​​for convenience and educational purposes. “TutoBuild Eng” makes no warranties of any kind and accepts no liability. “TutoBuild Eng” cannot be held responsible for any damage caused to devices or persons using information contained in this video. The use of the information contained in this video is at your own risk.

What else to read

If you like video and this material about “Brake bleeding with a Motive power bleeder pump step by step”, please visit our category NCT car prepare, where we help to explain how to prepare your car for NCT examination.

Please if you have any questions or comments you can leave them in the section on the bottom of the page.

0/5 (0 Reviews)

10 Comments

  1. This shit doesn't work. You see how slowly the fluid comes out? Yeah…. I get more pressure from pushing the pedal. What a waste of money it is. Motiv can cram it up their asses. 30 psi is a dribble.

  2. Great video. Is it ok to also give the brake pedal a few light pumps also? Kind regards

  3. Fantastic job thanks

  4. Dont top up your system with an un sealed container of brake fluid. It absorbs water as soon as you brake the seal. You don't want water in your braking system.

  5. Handy tool. Thanks for the video.

  6. Torque for bleeder valves 6-9 ft lb

  7. How you gonna get all the air out when the motive bleeder is putting air back in the system. You can clearly see the air trapped in the fill tube.

  8. Great job. Thank you sir.

  9. Nice job on the video. Thank you. I've never seen this pump before or how it works. Seems easier than the suction method done by a Mityvac, plus you don't need an air compressor (even though I have one). Doesn't seem too messy if you are careful. πŸ™‚

  10. Always start by bleeding the brake furthest from the master cylinder, then second furthest, etc.

Leave a Reply