Wheel bearing replacement on site without dismantling the hub carrier

“Wheel bearing replacement on site without dismantling the hub carrier” with video from Youtube

Video “Wheel bearing replacement on site without dismantling the hub carrier”

How to change a wheel bearing directly on the vehicle, without a press and without dismantling the hub carrier. All stages: hub removal with a slide hammer puller, extraction of the bearing, new bearing refitting, hub refitting with a wheel bearing tool set.

This video does not constitute or replace a real specialized technical manual, and was only made ​​for convenience and educational purposes. “TutoBuild Eng” makes no warranties of any kind and accepts no liability. “TutoBuild Eng” cannot be held responsible for any damage caused to devices or persons using information contained in this video. The use of the information contained in this video is at your own risk.

What else to read

If you like video and this material about “Wheel bearing replacement on site without dismantling the hub carrier”, please visit our category NCT car prepare, where we help to explain how to prepare your car for NCT examination.

Please if you have any questions or comments you can leave them in the section on the bottom of the page.

0/5 (0 Reviews)

10 Comments

  1. Ilyen szar munkát még nem látam, te inkább ne nyúljál kocsihoz !!

  2. "Hey guys chrisfix here"

  3. Im all for getting it done regardless of method, so i gave it a thumbs up.
    But i thought that the reason the whole thing was taken off was to avoid damaging the bushings and assure no damage to bearing on install.

  4. Мда… пока выбивал ступицу запорол шаровую и рулевой наконечник или тягу. а так если хочешь пое….ся то способ самое то.

  5. на кортанах так пол дня посидишь хер встанеш потом )))

  6. еще и заморозка нуууууу… снимаю шляпу )))))))

  7. Mych easier with the hub off but just shows it can be done both ways

  8. Had to mute it…

  9. Ольга Сергеева
    Ольга Сергеева

    В 90-х без инструмента также делал. Он только не показал как замораживал. Я замораживал эту деталь (забыл как она называется) используя сухой лед от огнетушителя ОУ-2. Съемников не было у меня только молоток и зубило. Теперь конечно не заморачиваюсь есть сервис.

  10. Bearing destroyed before going on the road.. good job

Leave a Reply